So, You want to know about a Series Vape MOD. In this article, we're going to explain the basics on vaping and how the Series Vape MOD functions.
First off, the Series Vape MOD is amazingly compact and light weight. The unit functions by drawing its power from batteries. Most batteries are rechargeable and positioned upright so that the electric current reaches the circuit at an even flow and steady pace. The concept is very basic. When the button on your MOD is depressed, electricity is released into the coil creating the vapor as you inhale. Unique to itself, the batteries together run the Series Vape MOD in a continues circuit. If one battery is removed from the battery chamber, the unit will not work. As you well know, there's potential for anything to go wrong when using electricity. There are many replaceable batteries on the market but, when you replace the batteries, you run the risk of explosion of your Series Vape MOD if the batteries are replaced incorrectly. While you may save money buying rebuilt atomizers, be aware of the danger that presents itself if you are not sure of what you are doing.
Now that you know how the Series Vape MOD runs, let's talk about how to change your vape liquid. The coil is located centrally in a small tank where the vape liquid is held. It's a small cylindrical piece that regulates the flow of your Series Vape MOD allowing the current to flow through the coil and out the inhalation vent. Many people prefer these particular type of units as the batteries are not close to the venting area. Your coil is basically an atomizer. An atomizer is a device that converts a stream of liquid into a mist like spray and in this case, your vapor.
You will know when it is time to change your coil as the flow of vapor becomes weak and interrupted. More advanced users may even rebuild the atomizer but , this is dangerous and should be left to the pros. To change the coil, simply open the tank and remove the old coil by pulling it upward. You then simply put the new coil in its place and close the tank lid. Adding vape liquid is super easy. You will find the tank lid on top of the base unit. It's easily unscrewed. Turn the lid clockwise and it should pop right off. The amount of nicotine you prefer is completely up to you. The liquids come in 24mg , 18mg, 12mg, 6mg, 3mg, and 0mg. The flavor you prefer is also your choice. There are literally hundreds of flavors to choose from. To add your vape liquid, simply open the tank lid and pour the vape liquid into the tank through the slotted top and replace the lid. It is that easy. Now you are vaping!
Share this post